Friday, 24 May 2019

5 Ways To Avoid Hard Water Stain On Your Car

Each type of water contains minerals like magnesium and calcium. Hard water stains appear on your car as the water leaves traces of these minerals when it dries. If you continue to allow it, the minerals, along with other dirt and debris, affect the finish and overall finish of your car. However, you can take action to avoid this problem. Here are some tips on how to prevent hard water from damaging your car.

1.
Always wipe the car dry when it gets wet
The easiest and most effective way to avoid water stains is to wipe the car dry after a wash, rain or any time it gets wet. Use old towels and microfiber
cloths to wipe off the water and do this every time after washing the rinse. Be sure to dry the painted surfaces, chrome and plastic parts of the car like the bumper. Go through each part several times to avoid leaving any water streaks, as these can also leave residues on the vehicle surface.

2.
Keep the car protected from rain

Many people believe that a rain shower will wash off the dirt from the car. However, rain and other groundwater sources may contain more minerals than tap water and other contaminants, increasing the likelihood of spotting. Etching "the paint job. During etching, minerals or foreign bodies get under the paint and cause small scratches on the unprotected parts of the vehicle surface. If possible, stop your car in the garage in case of rain and keep it away from sprinklers or other sources of water.


3.
Keep the car protected from extreme sunlight

High temperatures can accelerate the formation of corrosive water stains, as the sun burns off the water more quickly and only the residue remains. The more the stains are baked, the harder it is to remove them. (It is not recommended to have your car roasted in the sun at all times - even if you do not intend to wash it.) Never wash your car in high heat or sun, and wait until late afternoon or instead early morning, when the sun's rays are not so strong. Imagine painting the car like your own skin. The more it stays exposed, the greater the damage.


4.
Use vinegar wash to remove water stains

Instead of spending a lot of money on fancy water stain removers, you should use white vinegar as the main solution for removing water stains. Vinegar, which should not be used as a car soap, lowers the pH of hard water and removes stubborn water stains that have dried. After washing and drying your car with a suitable car soap, mix equal parts of vinegar with water (distilled water is recommended as it does not contain as many minerals as normal tap water) and wipe the whole car with a sponge or mainly at Water points off. Then, if possible, rinse thoroughly with distilled water and then wipe dry with micro-fiber cloths. Keep in mind that vinegar also removes wax or sealant, so you need to re-apply this protective layer after drying.

5.
Use a clay detailing bar to remove minor traces of etching

Vinegar removes water spots very well, but if they are too long, you may notice your car is suffering from causticization. If water marks etch the paint, you'll need to do a small damage control, and a great product to correct for this is a clay detailing bar. Firstly, wash the area with vinegar or soap and dry the surface. Then grease the surface with a preferred wax product and rub the clay in the affected area. Polish with a microfiber cloth until you are satisfied with the result. Follow the instructions of this product carefully and use it only if the etching traces are slight.




No comments:

Post a Comment